Your location: The Papier Mache ResourceForum

Forum

Note: The forum uses a separate login system to the galleries.

You are not logged in.

Options

  • Index
  •  » General
  •  » need to make a large head that can resemble someone, etc.

need to make a large head that can resemble someone, etc.

#1 2006-08-17 18:56:33

corkmt2003
Member
From: boston, ma
Registered: 2006-08-17
Posts: 1

need to make a large head that can resemble someone, etc.

I need to make a large head that will look like my brother in law.  I am going to be a pez dispenser for halloween, and want to head that pivots to be of him.  So basically i need a large enough head to fit over mine but also be allowed to tilt open.  So i origianlly thought, maybe paper mache a head, and have some artist/sculpture put clay layer over it( the face part) to make it look like him?  and the head will have to be strong enough to allow for a pivot screw set up in the back..  So i have no idea where to begin, so that's why i am here..  I got 2 months to get started so any ideas are all appreciated..  and i will see what i can do. thanks keith

Offline

 

#2 2006-08-18 05:10:22

CatPerson
Moderator
From: Washington State, U.S.A.
Registered: 2006-01-09
Posts: 1314

Re: need to make a large head that can resemble someone, etc.

I would find your artist/sculptor first, and work from there.

My thought was to have your artist make a clay-type head, then you can lay papier mache over it to make the head you need.  Or, as long as you can get an artist involved, have them make a plaster mold of the clay head, and make the PM head for you, from the mold.

Unless you have an artist friend who has time on his/her hands, this may be a rather expensive proposition.

Sue

Offline

 
  • Index
  •  » General
  •  » need to make a large head that can resemble someone, etc.

Board footer

Powered by PunBB
© Copyright 2002–2005 Rickard Andersson